background image

263LTE X1 SERIES INSTALLATION SHEET  |     DIGITAL MONITORING PRODUCTS 

2

X1-8 Applications

Header

Cell Module

Standoff

2

3

Door Controller

Cell 

Antenna

Cable

Cell 

Module

Door

Controller

4

Standoff 

Location

1

Tab

Door Controller

2

Cell 

Antenna

Cable

Cell 

Module

Door

Controller

1

Install the Cellular Communicator

1.  Plug the included standoff into the door or elevator controller board.

2.  Plug the cell module onto the standoff.

3.  Plug the cell module into the cell header.

4.  Screw on the cell module antenna cable to the antenna connector.

Remove the Cellular Communicator

1.  Unscrew the antenna cable from the antenna connector.

2.  Pinch the tab of the standoff to release the cell module from the door or elevator controller.

3.  Unplug the cell module from the cell header.

4.  If installing a new cellular communicator, go to step 2 of 

Install the Cellular Communicator

 above.

3

TEST THE CONTROLLER

Make sure that the reader LED(s) is on and the door or elevator controller’s power LED is on. Check that 

the door or elevator controller is communicating with Dealer Admin and Virtual Keypad after Dealer Admin 

programming is completed.

CONFIGURE CELL SETTINGS 

Once connected to an X1, the communicator will automatically register with the cellular carrier upon power up. 

 

Note: 

The cellular communicator comes pre-activated, so it cannot be activated through Dealer Admin, 

Remote Link, or by calling Customer Service.

2

Reviews: