DMMetering®
2007
Make sure the protection cover is placed after installation.
Installation, maintenance and reparation should only be done by qualified
personnel.
Never break the seals and open the front cover as this might influence the
functionality of the meter, and will avoid any warranty.
Do not drop, or allow physical impact to the meter as there are high precision
components inside that may break.
Exclusion of liability
We have checked the contents of this publication and every effort has been made to
ensure that the descriptions are as accurate as possible.
However, deviations from the description cannot be completely ruled out, so that no
liability can be accepted for any errors contained in the information given. The data
in this manual is checked regularly and the necessary corrections are included in
subsequent editions. We are grateful for any improvements that you care to
suggest.
Subject to technical modifications without notice.
Copyright
Copyright DMMetering November 2007 All rights Reserved.
It is prohibited to pass on or copy this document or to use or disclose its contents
without our express permission. Any duplication is a violation of the law and subject
to criminal and civil penalties. All rights reserved, particularly in the event of a
patent award or utility model registration.
Registered trademarks
DMMetering
®
is registered trademark of Inepro Industries Ltd – member of the
Inepro Group. The other names appearing in this manual may be trade names the
use of these names by third parties for their own purposes may infringe the rights
of the owners.
1.2 Foreword
Thank you for purchasing the DMMetering PRO-1TE series DIN rail single phase two
wire energy meter. The DMMetering PRO-1TE series energy meter is the most
advanced type electronic kWh meter available at the market. With the DMMetering
product range we have introduced a large scale of energy meters on the market
suitable for 110V AC to 400V AC (50 or 60Hz). Besides the normal energy meters
we also developed our own pre-paid meters with chip card, chip card re-loaders and
a complete PC management control system. For more information on other product
please contact our sales department at [email protected] or
[email protected].
Although we produce the DMMetering PRO-1TE series meter according to IEC
62053-21 and our quality inspection is very accurate there might always be a
possibility that your product shows a fault or failure for which we do apologize.
Under normal conditions your product should give you years of benefit and pleasure.
In case there is a problem with the energy meter you should contact your dealer
immediately. All energy meters are sealed with a special seal. Once this seal is
broken there is no possibility to claim for warranty. Therefore NEVER open an
energy meter or break the seal of the energy meter. The warranty time is 3 years,
after production date, and only valid for construction faults.
