Mounting Instructions
Choose a location to hang the dartboard where is about 10 feet (3.048 m) of open space in front of the board.
The “toe-line” should be 7’9 1/4” (2.37 M) from the face of the dartboard for steel tip rules or 8 feet for soft
tip rules. You will need to mount the board close to an electric outlet if your dartboard requires an AC adapter.
Always remove the batteries when you use an adapter. Regardless if the dartboard has horizontal or vertical
hang hole(s), the center of bullseye should be 5’8” (1.73 m) from the ground when mounted. (Figure A) Make
a small temporary reference mark on the wall at 5’8 inches from the floor. (do not drill a hole in the temporary
reference mark) Measure the distance between the top hang hole on the back of your board and the center of
the back of your dartboard. The center of the back of the dartboard is the middle point of the circle area on
the back of the board. Take a ruler and determine that distance. Then make the mark for the top hang hole on
the wall above the 5’8 mark by the distance you just measured. (see Figure B) Drill the screw into the mark
you made. Mount the dartboard on the wall by lining up the hang hole on the back with the screw. It may be
necessary to adjust the screws until the board fits snugly against the wall. If you want to mount the dartboard
even more securely to the wall, you can utilize the bottom hang holes located on back of the board as well.
You will need to make another temporary reference mark 12.54 inches below the top hang hole you drilled.
Then make a mark 5.31 “ to the left and another mark 5.31” to the right of the temporary mark for the
additional screw locations. Drill the screws into the two marks you made.
Figure A
