26
7
1.6 - Basic alarm cycle setting for calls towards service center
1)
Enter in programming mode (see § 3.4)
2)
Set the “1st number” with the phone number of the service center to be called in case of
emergency (see § 3.5)
3)
Set the “Service Calll no.” with the phone number of the service center to be called in case of
emergency (see § 3.6)
4)
Select the desired number of alarm cycles (see § 3.7)
5)
Select the type of “Incoming calls” (see § 3.8)
6)
Select
tone
mode (see § 3.9)
7)
Select conversation time (see § 3.10)
8) Set the ID number provided by the selected service center (see § 3.12)
9) Select the type of protocol to be used to communicate with the service center (see § 3.13)
10) Select the type of “Call delay” (see § 3.14)
3.12 - Site identification
When “Protocol Type” is set on either “ANEP” or “Ademco” or “Scantronics” (see § 3.13), the
autodialler does not send voice service messages but dialogues with service centers exclusively
through DTMF tones.
In such case, an ID Number must be entered into the autodialler. The ID number will be sent to the
service center and will allow the unique identification of the installation which generated the
emergency call.
To set the “ID Number”, press
WRITE
to access programming mode, then enter the site identification
number (max 8 digits). Press
OK
to store the setting (If
OK
is not pressed within 30 seconds, the
setting is cancelled and the system goes back to Stand by).
Id number
Protocol type
Id number
(MAX 8 digit number)
ESC
NEXT
WRITE
To store the number
OK
ESC
NEXT
Protocol type
Stand by
DMG
Amigo XX vX.X
Stand by
DMG
Amigo XX vX.X
If no key is entered within 30 seconds, the autodialler will automatically get back to stand-by.
AMIGO
Emergency telephone
AMIGO
Emergency telephone
