WARRANTY
– Warranty Support and Service for DLX Technologies (DLX) products is provided by factory trained service techni-
cians and DLX Authorized Service Locations. The DLX warranty is valid for one (1) year to initial retail purchaser. The warranty is
limited to defects and workmanship in materials covering the paintball marker and regulator components. The electronic com-
ponents and solenoid are warranted for six (6) months. Disposable parts (Batteries, O-Rings, Seals, etc.) are not warrantied. This
warranty is effective only if the customer registers their marker online in our RMA system within 30 days of purchase. The warranty
is non-transferable.This warranty is limited to repair or replacement of defective parts with the customer responsible for transport-
ing the product to and from the Luxe
®
Paintball Authorized Service Location.
This warranty does not cover surface damages (scratches and nicks), misuse, or improper disassembly and reassembly. Attempts
made to drill holes or remove metal from external surfaces could degrade the performance and/or safety of the marker and may
only be preformed with written approval. The only authorized lubricant for the marker is GR33SE™ Lubricant. Use of any other
lubricant could result in reduced performance and invalidation of the DLX warranty.
Trigger alteration of any kind may result in serious injury, do NOT attempt to alter the trigger assembly in any way. Use of aftermar-
ket components within the bolt system, trigger or other operational components voids any warranty on the modified assembly and
its interacting systems. Removal of factory anodizing or other finish voids the warranty of any affected component as tolerances
will be effected by such action. DLX strongly discourages use of aftermarket internal components as they may jeopardize the per-
formance and/or safety of your paintball marker.
DETENT/VISION CLEANING
– The Luxe
®
X Vision
®
anti-chop sensors and ball detents are housed under easily removed
covers on either side of your marker. Simply slide the cover’s latch forward, and rock the cover forward to remove it. A cotton swab
can be used to clean the electronic sensors, ball detents and the pass-through holes they use to access the breech.
TRIGGER ADJUSTMENT
– Your Luxe
®
X features four-point trigger adjustment. Each of the four settings may be adjusted
with a 1/16 inch hex key. Pre-Travel limits how far forward the trigger can swing. Post-Travel limits how far back the trigger can
swing. Activation point adjusts how far into the pull the trigger switch is activated to fire your Luxe
®
X, and trigger resistance
adjusts the strength of the magnetic field that resets the trigger. CAUTION – If the trigger is not adjusted to stop firmly on the Post-
Travel adjuster screw, permanent damage to the Luxe
®
X circuit board can occur from aggressive trigger pulls.
{FIG. 07}
Luxe® is a registered trademark owned by KEE Action Sports and used under license by DLX Technologies.
Freak® is a registered trademark owned by KEE Action Sports and used under license by Philadelphia Americans, LLC.
QUICK START GUIDE |
V.02
MECHANICAL ADJUSTMENT
LUXE X SETUP
WARRANTY
WARNING!
–
THIS IS NOT A TOY. MISUSE OF THE LUXE
®
X MAY RESULT IN SERIOUS INJURY OR DEATH.
EYE PROTECTION DESIGNED FOR PAINTBALL USE MUST BE WORN BY THE USER AND ANY PERSON WITH-
IN RANGE OF THE LUXE
®
X. DLX RECOMMENDS THAT THE LUXE
®
X ONLY BE SOLD TO PERSONS 18 AND
OLDER.
THOROUGHLY READ THE LUXE
®
X QUICK START GUIDE BEFORE OPERATING.
WWW.LUXEPAINTBALL.COM
u
u
u
u
u
u
07
TRIGGER ADJUSTMENT
Pre-Travel
Trigger
Resistance
Switch
Activation
WWW.LUXEPAINTBALL.COM
Post-Travel
BATTERY
– The lithium polymer battery in your Luxe
®
X must be fully
charged before use. Lift the left side of the rubber grip away from the Luxe
®
X, un-tucking the tab from its slot at the top. Connect the USB Type C
charging connector to the Luxe
®
X circuit board. Make certain the battery
is fully seated in the grip frame. Once connected to the Luxe
®
X, plug the
charger into a power outlet. The Luxe
®
X is compatible with standard USB
and USB-C chargers, allowing it to be charged directly from a portable phone
power pack, car USB power source, laptop computer or other USB compli-
ant power supply. The battery may also be removed and charged separately
with the optional Luxe
®
battery charger. Even if stored, the battery should be
charged at least once every 6 months.
{FIG. 01}
The following three steps must be followed to ensure the Luxe
®
X battery is
properly installed for reliable use: 1} Install the battery into its slot with the
electrical terminals facing downward. 2} press downward on the battery when
it is fully side into the battery slot, locking it into position. 3} Close the rubber
grip making sure to install the grip wedge above the battery top (between the
battery and top of the battery slot).
{FIG. 02}
WARNING!
– Incorrectly closing the rubber grip can cause intermittent
power loss. When closing the rubber grip make sure that the battery wedge
slides into the gap between the top of the battery and the battery slot.
The rubber grip wedge locks the battery in place to ensure solid electrical
contact. If the grip wedge is misaligned and folded against the front of the
battery, heavy impacts or shocks may break the electrical contacts causing
the Luxe
®
to power off.
{FIG. 02}
FIG. 2
01
CHARGING
02
BATTERY
Battery Wedge
(inside Grip)
Frame corner cutaway to show battery
Battery Slot
Hook
1}
Battery Orientation
for Installation
3}
2}
