DU8190Z DLP Projector - User Manual
29
UM81900217EN00
Connecting to the Control Equipment
The projector has the following control port for connecting to the control equipment:
HDBaseT/LAN (Network control):
The projector supports network control. LAN and HDBaseT share the one port. If
only network control is used, you can connect the LAN on the projector to PC or through the local network. Refer to the
Remote Communication Manual for detailed information.
RS-232 (RS-232 control):
The projector can be remote-controlled by connecting the projector to PC or control system
through the standard 9-pin serial cable (Straight Through Serial Cable). Refer to the Remote Communication Manual
for detailed information.
Wired remote control:
If the projector cannot receive the IR signal from the remote control due to the overly long
distance or obstacles, you can connect the cable to the IR remote control or the external IR transmitter (optional) via
the WIRE input port to expand the working range of the remote control.
3D Sync Out/In:
Connect to 3D IR sync signal transmitter or device.
Caution:
When the terminal of the remote control cable is inserted to the wired control terminal of the projector, the
projector will automatically switch to the wired control mode and cannot be controlled through the IR signal of
the remote control. Disconnect the wired control terminal on the projector if you want to control through the IR
signal of the remote control.
If the wired remote control cable or the external IR transmitter is inserted to the incorrect port, such as Trigger,
the remote control or the IR transmitter may be damaged. Make sure whether the port is correct
