Initial
operation
DLoG MTC 6
User’s Manual V1.00
41
5.7.
Powering up the DLoG MTC 6
Only power up the DLoG MTC 6 after connecting all of the devices.
The DLoG MTC 6 is powered up by connecting it to an appropriate power supply and
then, depending on the version of the device, either using the <Power>-key or the
ignition signal.
You have to hold the <Power>-key down for a short time.
Caution:
Property
damage
Make sure there is a suitable disconnecting device such as a power
switch or circuit breaker in the power supply circuit.
Figure 5.12: DLoG MTC 6 <Power>-key
<Power>-key
