DLI 7200 Product Manual
Rev. 1
31
SAM Card Installation
Part of the DLI 2-in-1 Module is an RFID Reader that requires a SAM Card to function correctly.
The SAM Card slot is found on the back of the 2-in-1 Module and has special instructions for
installation.
Warning! Do not install/remove module while unit is powered on or plugged in
to AC. ATTENTION! When removing the 2-in-1 module, please be aware of
exposed components. Use non-conductive tools. Do not remove module near
any liquids or debris.
1. Power down your DLI 7200 properly and remove AC (if plugged in).
2. Remove the 2 screws holding the 2-in-1 Module to the unit. Please be mindful of any
attached wires.
3. On the back of the 2-in-1 there is a SAM Card slot. Follow the instructions on the SAM
Card slot.
4. Lastly, line up the 2-in-1 Module on the back of the DLI 7200 and screw the device back
down. DO NOT over tighten.
If you have any questions please contact our Support.
Summary of Contents for 7200
Page 1: ...Rev 1 ...