www.dutchlightinginnovations.com
LED off, no blinking
(Normal operation - no action required)
Status (action)
Blink Code
LED continuously blinks
(No lamp detected or defect/broken lamp – Replace
lamp and reset fixture)
NOTE: This sequence only occurs in the first 20-minute lamp strike up period
NOTE: This sequence will occur after the 20-minute lamp strike up period
LED blinks 1 time
(Defect or broken lamp – Replace lamp and reset
fixture)
LED blinks 2 times
(Fixture is connected to DLM controller and in standby
mode, no action required)
LED blinks 3 times
(Mains voltage too low, check voltage)
LED blinks 4 times
(Ambient temperature too high)
LED blinks 6 times
(Mains voltage too high, check voltage)
LED blinks 5 times
(End of lamp life, replace lamp and reset fixture)
The output of the lamp can be regulated by the dim switch
on the bottom of the fixture. The typical output of the lamp is
1000W, but it can be adjusted to 600W, 750W, 825W, 1000W
and 1150W by putting the switch to the required output setting.
Dimming can be done during operation of the fixtures.
The fixture is equipped with soft-dim which gradually changes
the output to the new setting. This takes 60 seconds per step.
Before you dim or boost your DLI 1000W DE lamp, make sure
that you have run it at least for 100 hours at nominal level
(1000W) to stabilize the lamp.
The dim-switch can also be set to controller. This should be
done when the DLI DE 1000W fixture is connected to the DLI
Controller. Please read the instructions of the DLI Controller
first before connecting the fixtures to the DLI Controller.
Usage of the dim switch button
Usage of the controller
DLI fixtures come with a LED indicator: See below for blinking
sequence info.
LED indicator
Hanging distance
You need at least 3 foot or 90 cm distance between the fixture
and the plants. To check the height, place your hand (palm
down) over the plants. If your hand got too warm, you need to
move the lamp higher because than it is also too hot for your
plants and you will burn them.
Warranty
Returns
Dutch Lighting Innovations only uses high quality components.
Under normal operating conditions, the mechanical and
electronic components are covered by a three-year warranty
from the original date of purchase. For service return the fixture
in the original packaging to your shop with the original sales
receipt.
Components that are excluded from warranty are components
that have failed due to abnormal usage.
In the case of defects of the DLI JOULE-Series 1000W DE
fixture, the fixture will either be replaced or repaired using
new or reconditioned products or parts. If the fixture will be
replaced this limited warranty shall apply to the replacement
product for the remaining initial warranty period, i.e. (three) 3
years from the date of purchase of the original product.
The 1000W DE lamps are covered by a one year warranty from
the original date of purchase. Lamps broken due to abnormal
usage or thermoshock are excluded from warranty .
Broken fixtures need to be returned in the original packaging
without the lamp in order to avoid damages of the product
during transport.
To replace the reflector, make sure the lamp and reflector are
cooled down. Remove the lamp first. The reflector is held by 4
holding pins on the sides of the reflector cover (image 1).
The reflector can be taken out by carefully unlatching the top
of the reflector from the holding pins in the reflector cover
(image 2 and 3).
Latched reflector
Unlatched reflector
The Reflector
1
2
3
