12
safety instructions
The device can get very hot
. It must be operated in such a way that there are no heat-sensitive objects
near the device.
Please ensure that the device is always well-ventilated during operation
. Please be
aware that the device is still hot for a while after use. Please keep the device away from children, the
device develops a temperature level which can cause burns to the skin.
temperature and ventilation
The device must be operated in such a way that ventilation is guaranteed at all times
. Please never
expose the device to direct sunlight. External ventilation may be necessary in extreme operating
conditions.
EM interference
This equipment has been tested and found to comply with the defined limits for amateur radio
equipment. This device is tested in a laboratory, all measurements were applied with suitable
measuring devices. The device itself does not emit radio frequency energy to the antenna without a
connected amateur radio transceiver. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy
when it’s connected to a
n amateur radio transceiver and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
effected receiver device.
•
reduce the output power until the device no longer interferes.
• Consult the de
aler or an experienced radio/TV technician for help.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications to this device, not expressly approved by DIY599 could void your
authority to operate this device under compliance regulations.
This device is for use by licensed radio amateurs only
grounding and ESD protection
A connected transceiver should be connected to ground to provide some protection against lightning
and damage due to electrostatic discharge (ESD). When used in a building, the connected transceiver
should also be connected to other building grounds.
Summary of Contents for DIY599.com PA500
Page 11: ...11 ELECRAFT KX3 LAB599 TX 500 ...
