OFF
Opening
Direction of
SECONDARY
Operator
2
3
Terminal #4 is output from plug-in exit loop detector installed in EXIT loop port.
Same opening directions as illustrated above for the primary operator type.
• Switch 2 will be the OPPOSITE setting as switch 1.
Note: SW1, switch 7 MUST also be ON when using a secondary operator.
Exit Loop Port
Output
Open Input
ON (normal) Terminal #4 is normal open command.
OFF (normal)
ON
OFF
ON
Reverse
Not Used
Overlapping
Gates
5
6
Terminal #8 is a standard Reverse input.
On setting is NOT used.
Both operators start at the same time.
Secondary operator opens 1-2 seconds before primary operator. Vice-versa when closing.
OFF
ON
Single
Dual
Switch must be OFF for single operator.
Switch must be ON when (dual) operators are used.
Input Power
Switch MUST be in the OFF position.
OFF
8
7
OFF
ON
Auto-Close
Timer
4
Auto-close timer is OFF. Manual input required to close gate.
Auto-close timer is ON. Adjustable from 1-23 seconds.
Switch Function
Setting
Description
1
Opening Direction of PRIMARY Operator
SW 1
SW 2
1
ON
2
3
4
5
6
7
8
1
ON
2
3
4
SW 1 DIP-Switches
SW 2 DIP-Switches
Note: After a DIP-switch
setting is changed, press the
reset button for new settings
to take effect.
Switch
Function
Setting
Description
1-OFF
1-OFF
1-ON
1-ON
2-OFF
2-ON
2-OFF
2-ON
Relay activates when gate is fully open.
Relay activates when gate is not closed.
Relay activates when gate is opening and open. Shadow loop setting if used.
Relay activates when gate is opening and closing.
Spare
Leave in the OFF position.
OFF
Relay
Operation
1 and 2
3
4
1 second delay to disengage maglock.
Leave in the OFF position if a maglock is NOT used.
ON
OFF
Maglock Used
No Maglock
Power safety and opening devices
that require 115 VAC power.
Three 115 VAC Convenience Outlets
Deluxe
115 VAC
Control
Box
Key Switch
(Dry contact)
Keypad
(Dry contact)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
Switch 3 ON
Controls must be far
enough from the gate so
that the user is prevented
from coming in contact
with the gate while
operating the controls.
Do not power any control
devices from the circuit
board other than low
voltage devices.
Com
Com
Com
N.O.
N.O.
N.O.
N.O.
Com
Com
N.C.
Power Com
Relay Com
Relay
Power
Rela
y
Co
m
Powe
r
Magnetic Lock
4-Wire
RF Receiver
Safety Opening Device
(Dry contact)
Switch 3
MUST be
ON.
Telephone Entry
Note: Must use a
separate power source.
Note: Circuit board provides
24 VDC to power maglock.
Contact rating is 1 amp
maximum at 24 Volts.
SW 1
1
ON
2
3
4
5
6
7
8
SW 2
1
ON
2
3
4
Connect optional control devices to
the main terminal. Use 18 AWG wire
for all low voltage wiring, maximum
distance 3000 feet. Use a low voltage
surge suppressor, (DoorKing P/N
1878-010) if low voltage wire runs
exceed 1000 feet. All control device
inputs to the terminal must be
NORMALLY OPEN.
Low V
oltage Common
Low V
oltage Common
Low V
oltage Common
Low V
oltage Common
Dr
y Relay Contact
Alarm Reset
Dr
y Relay Contact
24 VDC - 250 ma max.
Full Open
Full Open
Full Open
Standard Reverse
Not Used
Not Used
DC Lock Power Common
24 VDC Maglock Power
12 V
olt Batter
y Input
Low V
oltage Common
24 V
AC Input
24 V
AC Input
Main Terminal
3-Wire
RF Receiver
Reversing input on
Terminal #8
functions ONLY
while the gate is at
the FULL OPEN
position or during the CLOSING cycle. It
MUST NOT be used as an input for a
secondary entrapment protection device
during the OPENING gate cycle. Refer to
Secondary Entrapment Protection Wiring
in the Wiring/Owner’s manual.
OFF setting.
Opens clockwise.
ON setting.
Opens counter-clockwise.
ON setting.
Opens counter-clockwise.
OFF setting.
Opens clockwise.
Left-Side
Right-Side
QUICKSTART “BASIC” GUIDELINES FOR MODEL 115 VAC 6004 - DIP-SWITCH AND WIRING REFERENCE
120 Glasgow Avenue
Inglewood, California 90301
U.S.A.
Model 115 VAC 6004 is intended for installation only on swing gates used for vehicles.
Pedestrians must be supplied with a separate access opening. For safety and installation instructions, please refer to the
6004 Actuator Arm and Control Box Mounting manual and the 115 VAC Control Box Wiring/Owner’s manual.
