36
Once installed the DK Meter Online app. Will
identify your meter and check for the newest
available software for your meter.
By hitting the Advanced button, you gain
access to the Cloning (saving and loading from
file) facility, as well as the ability to install a
software license key that you may have
acquired for your DK Meter.
Signal connections
Included Signal Cable
The supplied cable harness has three BNC connectors. These allow three AES-3id digital audio signals to be
connected to the 75 ohm inputs. Because each AES input is a dual channel path, up to six digital mono signals
can be brought into the meter. These can be either 16 or 24 bits in depth and the intended sample rate is 48K.
An internal matrix allows the required signals to be routed to the measurement and display system. SPDIF
signals can also be connected and are accepted.
The meter also has two balanced analogue inputs and if required, the matching cable may be acquired from DK-
Technologies.
D-Sub Connector Pin-out
The 15 pin connector is shown from the wiring side of the cable mounted male connector.
Pins 5 and 13 are used for factory diagnostics only and it is essential they are left unwired.DK-Technologies A/S
Page DK Meter
Signal
Type
Pin
Signal
Type
Pin
AES 1
Signal
3
USB
Data +
2
AES 2
Signal
4
USB
Screen
Shell
AES 3
Signal
12
Analogoue L
Hot
6
AES
Ground
11
Analogue L
Cold
14
USB
0V
1
Analogoue R
Hot
8
USB
+5V
9
Analogue R
Cold
15
USB
Data -
10
Analogue
Ground
7
