DK-TEC BCRI, User Manual, Page: 11 / 15

11
11.
After mowing the first 50 meters, stop and check that the flail mower is adjusted
correctly.
12.
Do not make sharp turns while the mower is on the ground.
13.
Do not engage the PTO with the mower in the raised position.
Section 2: Adjustments
Leveling the flail mower:
NOTE: Tractor and flail mower must be level.
Leveling can be adjusted on the tractor's 3-point arms and center link.
Adjusting the cutting height:
The cutting height of the flail mower depends on the position of the rear roller.
1. Remove the bolts holding the roller on both sides.
2.
Raise or lower both sides of the roll in equal measurements.
3. Replace bolts and tighten.
3-point suspension Adjustments:
CAUTION, Engage the parking brake, turn off the tractor, remove the key and
engage the PTO before adjusting the height!
Belt tension. CAUTION , Belt drive system under spring tension; Use caution to avoid
personal injury!
The belt tension must be checked after the first 20 hours of use. And then after every 40
hours of use.
1.
Tension on the belt can be adjusted with the belt tension bolt. Turn the bolt until the
desired tension is achieved. When the belt is at the correct tension, the gearbox should be
adjusted so that the extension of the gearbox runs straight (parallel) with the flail mower.
Loosen the bolts at the bottom of the gearbox and move the gearbox until the gearbox
extension runs straight.
2.
Excessive belt tension can lead to premature failure of the belt and drive components.
CAUTION Excessive belt tension can lead to premature failure of the drive
components. Excessive belt tension can also lead to injury to the user or bystanders.