Heat Water
Temperat: 50°C
Heat Water
Turn on:no
10
Boiler temperature controller EKOSter 420
Note:
The symbol that the display shows: or indicates
the current temperature change trend in the boiler: indicates
the trend to reach the set temperature; indicates reduction of
the temperature in the boiler to the value specified by the "HI"
parameter.
When you feed fuel to the boiler, stop the blower. Do this by pressing the button
the display will show the symbol with a countdown to restarting. The time
required for fuel feeding is set in the WORK PARAMETERS maintenance menu -
see the Blower pause - fuel feeding. .
Pressing the button during the
countdown will exit the fuel feeding
mode and return of the controller to
automatic mode.
1:30 Temp:56
°
If you press the button again will
take you to a screen where it is possible
to enable or disable the domestic hot
water pump functionality. The setting is
made using the buttons: or .
.
During operation of the controller press
the button the display will show the
screen for setting the required tempe-
rature of the heater. Set the required
temperature using the buttons: to
increase the set point value, or to
reduce it.
Note:
The prerequisite for entry into the set operating
parameters of the hot water heater is to connect the sensor hot
water heater.
12. Setting the operating parameters of the domestic hot
water heater
11. Feeding fuel to the boiler
10. Setting the boiler operating parameters and lighting up
!
!
Change range: 40
°
C
÷
70
°
C
Factory setting (typical): 50
°
C
Change range: yes / no
Factory setting: no
