©2013 DJI Innovations. All Rights Reserved.
9
connection
CAN-Bus port on the WKM system.
port on the PMU V2 module.
(2) GCU Power Cable
connection
Connect the
GCU Power Cable
to a connecter, if DJI Multi-rotor is used,
solder the power cable to the power pad on aircraft.
(3) Gimbal TILT Control channel
X3
X1
4.
Connection has been finished. They can come into use after power on.
5.
The tilt direction of gimbal can be controlled by one channel of Autopilot System (WKM is X3, NAZA-M and
NAZA-M V2 is X1). You are asked to set the corresponding channel on your Transmitter, and connect the
corresponding port of Receiver to the Main Controller. Use the Gimbal Assistant Software to help you with
configuration.
Notes:
(1)
For H3-2D to work; it MUST be used in conjunction with Naza or WKM; do not power up the gimbal
without Naza or WKM connected.
(2)
Make sure to power on the gimbal after camera mounting, since the wrong center of gravity will cause
motor overheating and then lead to damage.
(3)
Re-do the Transmitter calibration after NAZA-M Firmware upgrade and double check other items.
(4)
Make sure connections are correct; otherwise may lead to the gimbal work abnormally or damage
，
even
cause the autopilot system working abnormally.
GCU and DJI Autopilot System Connection
