©2012 DJI Innovations. All Rights Reserved.
5
Assembly
STEP1.
Fix the OSD controller on your aircraft.
STEP2.
Connect the OSD with the video signal source, wireless video TX module, DJI autopilot
system and R/C receiver. Make sure the connection is correct in accordance with the wiring
diagram.
STEP3.
Setup a 3-position switch on the R/C TX as the OSD control switch.
STEP4.
Connect your wireless video RX module with the display screen.
3-Position Switch Control
Choose a 3-position switch channel and make sure you connect the correct channel of the receiver to
the OSD switch port.
Position -1
Position -2, (hold position -2 for 1.5s)
: every toggle from
Position -1 to Position -2
increases
the channel of the wireless video transmitter
module by 1 (from CH1 to CH8), only for
the wireless video transmitter module specified by DJI.
Position -3
Position -2, (hold position -2 for 1.5s)
:
toggle the switch to select the required
video input, when there are two video inputs.
Only the toggle from
Position -3 to Position -2 can
change the video input source.
Position -1 Position -2 Position -3
