4
©
2015 DJI. All Rights Reserved.
EN
5. Assembling the Propellers
The propeller cover mounting screws (M3×8) should be adjusted using an
appropriate hex key.
1) The propellers marked CW should be mounted to the clockwise rotating
motors, which have a mark. The propellers marked CCW should be
mounted to the counter-clockwise rotating motors, which have a mark.
2) Use two propeller cover mounting screws (M3x8) to mount and secure
the propellers. First line up and apply thread locker into the thread of the
propeller mount, then tighten the screws.
Loose screws cannot be securely locked in place with thread locker.
6. ESC Port Description
There are two ports on every ESC. They are the Outer ESC LED Port and the
Data/ESC Firmware Update Port. These ports will be clearly marked on the ESC.
Ensure that the ESC firmware is up to date and is compatible with the
motor you will install. Refer to the tag on the back of the ESC to see the
default version of the firmware.
Mount the outer ESC LED Indicators according to your needs.
The Data/ESC Firmware Update Port is used to update
the ESC firmware and adjust the ESC. To do this, visit the
official DJI website to download the DJI ESC Assistant.
http://www.dji.com/product/e1200-standard/download
Screws for Propeller
Cover (M3×8)
Clockwise
Counter-clockwise
CW or CCW Mark
7. Using the DJI ESC Assistant
The DJI ESC Assistant is used to upgrade the ESC’s firmware, configure the
propulsion system, etc.
An Updater is required and is not included with the E1200 Standard.
To use the DJI ESC Assistant, connect the ESC to a computer through
the Updater, as shown below.