26
Rear Facing Use:
5-35 lbs.
(2.3-16 kg),
19-36” (48-91 cm)
27
3
Rear-Facing Installation with
Vehicle Belt:
Thread the vehicle lap or
lap/shoulder belt
combination through the
rear-facing belt slot.
Thread UNDER seat pad in
front of crotch strap and
out opposite side. Buckle
vehicle belt.
Do not place vehicle
belt over child’s legs.
2
Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint rear-
facing in the back seat.
With child restraint in the
reclined position, make sure
level line on side of shell is
level with ground. Adjust
child restraint if needed.
NOTE:
Hook the top
anchorage strap’s hook to
recline stand.
1
With weakest hand at
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
seat belts do not loosen,
your child restraint
should be secure.
NOTE:
Some “play”
from front to back or
about an inch from side
to side is acceptable. If it
moves more, review
“Knowing your Vehicle
Belts” and “The Locking
Clip” sections.
After checking for hot
seat and buckles, secure
child as described in
“Securing Your Child in
the Child Restraint”
section.
5
WARNING
!
Using this child restraint in any vehicle
seat where the lap belt cannot be
tightened securely and properly or where
it can be loosened by pulling on it can
result in serious injury or death.
4
Push down firmly on the
child restraint and pull
up on belt to tighten.
For a manual belt, refer
to “Knowing your
Vehicle Belt” section.
Pull up on shoulder
strap to remove any
slack.
NOTE:
Locking clip is
shown installed.
6
4358-3775B Scenera OHB 5/30/06 2:09 PM Page 29
