6
OPERATIONS
1. Push Power button to on.
2. Insert target light for illumination the stylus.
3. Place a record on the turntable mat. When playing
a 45rpm record with a large center hole; place the
45-rpm adapter on the center spindle.
4. Set the rotation speed (33/45/78) to match the
record.
5. Release the arm clamp.
6. Set the cueing lever to the up position.
7. Press the Start/Stop button and the turntable
platter will start to rotate.
8. Move the tone arm over the desired groove.
9. Set the cueing lever to the down position, the tone
arm will descend slowly onto.
The record and play begins.
10. Set the desired pitch adjusts range by depressing
the buttons until the desired pitch is reached.
Options are +/-10%, +/-20% or +/-50%.
11. Adjust the pitch to a desirable speed, move the
pitch control slider up or down to adjust the speed.
12. To suspend play, lift tone arm with cueing lever.
13. When play is finished, raise the cueing lever,
move the tone arm to the arm-rest and secure the
tone arm with the arm clamp.
14. Press the Start/Stop button to stop the platter
rotating.
15. Push the Power button to off.
SET-UP
Headshell and Cartridge Assembly
When installing a cartridge, refer to the operating instructions of that cartridge. During installation, attach the
stylus protector to guard the stylus tip from damage.
Connect the Headshell lead wires to the cartridge terminals. The terminals of cartridges and the Headshell lead
wires are color coded. Connect each lead wire to the cartridge terminals of the same color.
White (L+) .............……………....Left c
Blue (L-) ....……………................Left channel -
Red (R+) ..…………....................Right c
Green (R-) .......…………….........Right channel -
Turntable Assembly
A. Headshell :Insert the Headshell into the front end of the Tonearm Assembly. While holding Headshell firmly into
he front end of the tonearm assembly, turn the Headshell Locking Nut counter-clockwise to firmly securethe
Headshell to Tonearm Assembly.
B. Counterweight : Locate and remove the tonearm Counterweight from the packaging. Slide Counterweight onto
therear of the Tonearm. Turn it lightly and it will screw onto the rear shaft of the tonearm.
