3
FEATURES
-
Professional 4-channel ultra-low noise DJ mixer
-
8 x State-of-the-art 24-bit digital effects with advanced parameter control
-
Intelligent dual auto-BPM counter with time and beat sync display
-
Super-smooth dual rail faders and crossfader for long life cycles
-
Adjustable crossfader curve for all mixing styles
-
3-band kill EQ (-32 dB) and precise level meters
-
Additional 3-way kill switches with extremely steep frequency separation
-
Monitor and Talkover function
-
High-quality components and exceptionally rugged construction ensure long life
-
Master/ Zone/ Record RCA output. Balanced XLR Master Output
PART NAME AND FUNCTIONS
(Rear Panel)
1. AC inlet and fuse holder. Use the supplied AC cord to connect the unit to AC mains. Make sure
voltage and frequency stated on the unit comply with your local AC supply. The fuse can be
accessed by the small drawer at the AC inlet. To change the fuse, unplug the AC cord first, pull out
the fuse drawer and replace the fuse ONLY with a fuse of SAME voltage and rating. If the fuse
blows again after replacement, hand over the unit to qualified service personnel.
2. Power switch. Switches the unit on and off. Make sure to switch the unit off when not in use.
3. Main stereo output. This is a balanced stereo output carrying the main output signal controlled by
(23).
4. Main stereo output. This is an unbalanced out carrying the same signal as output (3).
5. Zone (Booth) stereo output. This is an unbalanced output carrying the booth signal controlled by
(24). This output can be used for a 2
nd
zone which needs independent volume control, such as the
DJ booth or the seating area of a club.
6. Record output. This is an unbalanced stereo output carrying the same signal as the main output
(3), but not influenced by the main volume control (23). This is normally used for recording the
output to an external tape, CD or memory device.
7. Line inputs. These RCA connectors provide inputs for line-level signals to the assigned channels.
8. Phono Inputs. Depending on the position of the selector switches (9), these RCA connectors
provide the following inputs: (A) Position “PHONO”: input for phono-level signals to the assigned
channels, featuring the necessary RIAA equalization. (B) Position “LINE”: input for line-level
signals to the assigned channels. Note that if the Phono inputs are not used and the sensitivity is
switched to “PHONO”, the inputs shall be terminated with the supplied termination plugs (as
factory-inserted at delivery).
9. Sensitivity/Equalization selectors for inputs (8).
10.
Microphone input for CH1. This is a balanced ¼” TRS connector without phantom power provision,
hence only suitable for dynamic microphones.
