Wiring
Diagram
7
Solder and insulate all connections (Crimping should be avoided wherever possible)
WARNING
All rights reserved. ©2011 DIY TRACK
A.
Connect Pin7 yellow wire/cable to the yellow wire/cable (86) of the relay
B.
Connect the white wire/cable (85) of the relay to a constant 12/24v source
C.
Cut the positive wire of the vehicle ignition coil / fuel pump / solenoid etc
D.
Connect the green wire of the relay (30) to one end of the positive wire that you cut
E.
Connect the green wire of the relay (87a) to one end of the positive wire that you cut
Power cut relay
(Optional connection)
This connection is to remotely immobilise your vehicle. Please be cautious if installing
this optional immobiliser function as large currents are carried when starting the vehicle
and we would hate for you to have an unplanned vehicle stop due to an installation failure.
+12/24v
Pin2 Orange
Pin9 & 10 Red/Black
Pin5 White with Black = Future use
Pin6 Black
Pin1 Red
Pin3 White
Pin7 Yellow
Ignition Coil
Fuel Pump
Solenoid
Panic Button
10amp fuse
86
85
87a
30
+12/24v
B
A
C
D
E
Relay
1 2 3 4 5
6 7 8 9 10
Pin8 Blue
Pin4 Green
Refer to your vehicle/owners manual to confirm if the vehicle central locking
actuator is a positive trigger or a negative trigger.
If your actuator is a POSITIVE trigger then connect the PIN 4 Green cable/wire
to the signal cable/wire of the actuator
If your actuator is a NEGATIVE trigger then connect the PIN 8 Blue cable/wire
to the signal cable/wire of the actuator
Cenral Locking Actuator
Siren
86
85
87a
30
Relay