DISASSEMBLY OF DROP ELBOWS
1)
Remove the four 3/8” bolts securing the elbow to the bottom assembly.
2) For 6200, 6400 & VR6200 Elbows
R
emove the 3/8” NC Nylon Lock nut and nylon washer holding the
actuating arm in place. Separate the elbow from the bottom assembly.
For 6500 & VR6500 Elbows
Remove the 3 hex head bolts holding the arm pivot plate to the elbow
body.
3) Drive out the spring pin that holds the aluminum actuating arm to the
stainless steel stem. For the 6000 D-Handle elbow drive out the pin
holding the Bronze D-handle to the stainless steel stem.
Note:
For the 6400 co-axial elbows remove the center fluid tube by loosening
the set screw on the elbow. Remove tube and replace with longer tube,
new u-cap seal & 2 0-rings provided. Re-tighten set screw.
ASSEMBLY OF KIT TO DROP ELBOW
1) Install the stainless steel extension by sliding it over the existing stem
and driving the original spring pin through the lined up holes.
2) For 6200, 6400, 6500, VR6200 and VR6500 side link elbows, attach the
actuator arm to the stainless steel extension using the supplied
5/16” X 1” pin.
3) For the 6000 D-handle type elbows, attach handle to the stainless steel
extension with the supplied ¼” X 1 1/8” pin.
4)
Place the 3” extension casting over the bottom with the flat flange on the
bottom, insuring the
4.25” body O-ring is in place (included in kit). Using
the 3/8” x 1.5” Bolts & lock washers included in the extension kit, attach
the extension to the bottom casting.
5) Place the
other 4.25” body O-ring (included in the kit) on the extension
casting. Using the original 3/8” Bolts and the supplied Nuts & original
lock washers secure the elbow to the top.
6) For the 6200 and 6400 side link elbows, place actuator arm on stud on
elbow. Replace nylon washer and tighten lock nut.
0
090081 R8
6400 Co-Axial Drop Elbow
Extension Kit Installed
6000 D-Handle Drop Elbow
6200 Side Lever Drop Elbow
Actuator Arm
SS Stem
Extension
Extension
Casting
Lock Nut
D Handle
Bottom Assembly
Arm pivot
plate
6500
Side Lever
Drop Elbow
