15
Insert locating pin.
Step 7. INSTALL KNIFEHOLDER
Install the Knifeholder into the grinder.
Inserts face to the outside. You won't believe
how many operators put them in backwards!
Step 6. Replace the #1155 inserts in the
#2930 knifeholder. Use the insert removal
tool #10315 shown above. Do not drive the
inserts out from the outside edge, you will
shear the pins that locate the knife inserts.
Use a soft mallet, a block of soft wood or soft
plastic to tap the inserts in place.
Do not use a steel faced hammer!
Check the knifeholder for flatness after the
inserts are installed, it should not rock.
Knifeholders that rock do not work. If there
is any clearance, a few thousands of an inch,
it may be at the center of the knifeholder.
Clearance at the outside will cause the
grinder to fail to function. Ok, I know a 4-
bladed knife is shown and you are using a 2-
bladed knife, it still has to sit flat.
