ASSEMBLY TEMPLATE
REVISION LEVEL
EMK
11/8/16
CREATED DRAWING
REV.
A
-
DWN
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
1114K & KF, 1116K & KF
8' INSTRUCTOR DESK
ASSEMBLY INSTRUCTIONS
REV A
6 OF 8
NTS
EMK
11/8/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
NOTE:
1.
ALL WATER, ELECTRICAL, AND GAS CONNECTIONS SHOULD BE
PERFORMED BY A TRAINED PROFESSIONAL PER LOCAL CODE.
STEP 5:
IF YOU DO NOT HAVE A "K" SERIES UNIT, SKIP TO STEP 6. APPLY SILICONE ADHESIVE TO THE SINK
OPENING ON TOP. LOWER SINK INTO OPENING. WIPE OFF ANY EXCESS CAULK AND ALLOW TO
SET. LET CURE FOR 6-12 HOURS.
STEP 6:
ATTACH RUBBER MOLDING TO BASE OF INSTRUCTOR'S DESK USING CONTACT CEMENT. AFTER
MOLDING IS IN PLACE, SCREW STAINLESS STEEL CORNER BRACKETS ON EACH CORNER OVER BASE
MOLDING WITH THE SCREWS PROVIDED. IF YOU HAVE A "K" SERIES UNIT, INSTALL FIXTURES IN THE
HOLES PROVIDED ON TOP. INSERT ROD SOCKETS INTO PRE-DRILLED HOLES IN TOP. SEE NEXT SHEET
ON HOW TO INSTALL UPRIGHTS AND CROSSBAR.
TOP VIEW OF INSTRUCTOR'S DESK SHOWN
APPLY SILICONE ADHESIVE
HERE FOR SINK
TOP
FIXTURES
ROD SOCKETS - TYPICAL
COMPLETE UNIT SHOWN
APPLY RUBBER
MOLDING HERE
DWG To PDF.pc3
