45
I25
I24
I23
I22
I21
I20
tr
sv
pt
pl
no
it
fr
fi
es
en
de
da
cz
cn
Preparation for operation
Batteries
Safety measures when working with batteries:
Battery connection diagram
Charging procedure (traction block batteries with integrated charging
unit)
After completing the charging and with immediate use:
Charging procedure (traction block batteries with external charging unit)
Attaching tools
Check:
• that the brushes are not below the red marking and that the bristle length is
no less than 1 cm.
Caution:
Only maintenence-free gel traction block batteries may be used!
Please follow the instructions of use for your battery charger!
• Protective goggles must be worn when working on the
batteries.
• Do not subject batteries to an open flame or heat as there is a
danger of explosion from the electolytic gas present in the
cells!
• No smoking!
• Danger of chemical burns!
Caution:
The battery must always be clean and dry. Do not place any
metallic objects on the battery.
The integrated charging unit is only suitable for maintenance-free
gel traction block batteries.
Caution:
Batteries may only be installed or dismounted by customer
service personnel or specialists approved by Diversey who are
aware of all the safety regulations that apply here!
50A
Charger
BMS
DP
DV
Control
Dashboard
BM
2
6
5
4
3
2
1
SM
• Stand the machine on the parking support
before starting the charging procedure.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Plug the power supply cord into the mains socket.
• The yellow indicator lights up permanently until
approx. 90% of the battery capacity has been
reached. After that, the indicator blinks until the
battery is fully charged.
• When the charging process is complete, the
green indicator lights up.
In order to protect the battery, the charging sequence is not
started after a short period of use of less than approx.15 minutes,
and the green lamp lights up immediately.
In this case, the battery is charged to more than 75%.
• Leave the power supply cord connected to the mains until you use the
machine again. The on-board charger unit automatically monitors and
charges the batteries. The energy consumption in the mode is limited to a
few milliwatts.
• If a fault occurs during the charging process as the result of a defect in the
charging unit, an interruption of a cable or a defective battery cell, the red
indicator will light up.
• Unplug the connection to the mains socket.
• Connect the battery to the machine with the battery disconnection socket.
• Check that the machine is switched off.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Connect the battery disconnection socket to the external battery charging
unit (pay attention to the voltage from the mains supply socket).
Caution:
Follow the instructions of use for your battery charger!
• Switch the machine off.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Place the machine on the parking support.
• Remove the brush holder (2) by screwing off the
triangular handle (1).
• Insert the brush into the brush housing.
• You can push the brush upwards with your right
hand so that it will be taken up by the centring
hexagon in the brush housing.
2
1