Dive Gear Express DGX Gears XTRA Regulator, Service Manual

Page: 21 / 26

9. Install the HP Seat Retainer into the body and torque this to 130 in­lbs/ 150 kgf cm/ 15 Nm ­ Fig. 45.
Fig. 45
10. Once the HP Seat Retainer is torqued to its proper specification, install the rubber End Cap (34) onto the
regulator body. Orient the groove in the side to line up with the DIN Inlet on the body ­ Fig. 46.
Fig. 46
11. Place the Saddle (08) over the DIN Inlet. Insert the Filter (D11) and O­ring (D7) into the DIN Filter Retainer
(D10), as shown on the schematic ­ Fig. 47.
Fig. 47