DTK-DF240M
(Surge Module)
The DTK-DF240S12 is a series connected Surge Protective Device, for 12 individual
loads, with a replaceable surge module for each load. The LED indicators on the top
face of the DTK-DF240M surge module provide power, ground and surge module
health status. When the DTK-DF240M surge module has gone end of life, the large
“REPLACE” RED LED will illuminate and the “GOOD” Green LED will turn off. Also,
the audible alarm will sound to provide an extra alert to indicate the surge module’s
health. To silence the alarm, remove the dead module and replace it with a new,
unused module. If a new module is not available, the alarm can be silenced by
moving the toggle switch into BYPASS mode. When a new DTK-DF240M surge
module is installed, this toggle switch must be moved to the center, or the “NORMAL”
position before installing the new module. The red polarizing keys insure that the
correct voltage module will mate with its corresponding base.
WARNING: When the DTK-240M module has gone end of life, or is missing, the
base is susceptible to damage from surge energy. Make sure you always have a
spare module available. No substitutions shall be permitted.
Front
Back
MODULE
STATUS
ENERGIZED
GROUNDED
GOOD
REPLACE
L1
N1
IN
L1
N1
OUT
L2
N2
IN
L2
N2
OUT
DITEK
Surge Protection
MODULE
STATUS
DTK-DF240M
240VAC
R
ENERGIZED
GROUNDED
GOOD
REPLACE
MADE IN USA
DEFLECTOR
SERIES
Pat. www.diteksurgeprotection.com/patents
Model: DTK-DF240M SPD TYPE 2CA
Electrical Ratings: 240VAC, 20A, 50/60 Hz, Single Phase
Nominal Discharge Current Rating: (In): 10kA, SCCR: 5kA
MCOV Rating: 320 L-N, 320 L-G
VPR: XXXX L-N, XXXX L-G
Suitable for use on a circuit capable of delivering not more than
10,000 rms symmetrical amperes, 240 Volts maximum when pro-
tected by a 20 ampere circuit breaker rated 240 volts minimum.
Convient a des circuits produisant au plus 10,000 A eff.
WARNING - SHOCK HAZARD - DO NOT OPEN
AVERTISSEMENT - RISQUE DE CHOC
NE PAS OUVRIR
C
UR
US
