UNIWAVE Series
Product Description
The UNIWAVE Series is a new range of modern wireless interfaces which allows users to manage all comfort settings for a room. Allure UNIWAVE is a
wireless wall-mounted sensor which is particularly suitable for renovation or retrofit projects or areas where wiring is impossible.
General Installation Requirements
For proper installation and subsequent operation of the device, pay special attention to the following recommendations:
£
Allow for proper clearance, at least 15cm (6”), around the device’s enclosure to provide easy access for hardware configuration and maintenance.
£
The device must not be installed in a place where it can be affected by direct sunlight.
£
Install the device in a location of average temperature and approximately 1.5 m (5 ft) above the floor.
£
The device should not be installed on an exterior wall.
£
The device should not be installed near a heat source.
£
The device should not be installed near an air discharge grill.
£
Install the device in an area that provides proper device ventilation. Nothing must restrain air circulation to the device.
£
Upon unpacking, inspect the contents of the carton for shipping damages. Do not install a damaged device.
£
Orient the device with the ventilation slots towards the top to permit proper heat dissipation.
£
The device is designed to operate under the following environmental conditions:
– Operating temperature from 32°F to 122°F (0°C to 50°C)
– Storage temperature from 32°F to 122°F (0°C to 50°C)
– Relative humidity from 0% to 80%, non-condensing.
The UNIWAVE device has not been designed for outdoor use.
Any type of modification to any Distech Controls product will void the product’s warranty
I n s t a l l a t i o n G u i d e
