H a r d w a r e I n s t a l l a t i o n G u i d e
DA-088N Series
Damper Actuator, 88lb.-in., Non-Spring Return, 24V
Figure 1: DA-088N Series Damper Actuator
Product Description
This document describes the hardware installation procedures for the
direct-coupled mounting of the DA-088N Series damper actuators.
General Installation Requirements
For proper installation and subsequent operation of each actuator, pay
special attention to the following recommendations:
-
Upon unpacking the product, inspect the contents of the carton for
shipping damages.
Do not install damaged actuators.
-
Avoid areas where corroding, deteriorating or explosive vapors,
fumes or gases may be present.
-
Ensure that all equipment is installed according to local, regional,
and national regulations.
Personal injury or loss of life may occur if you do not follow a
procedure as specified.
Equipment damage or loss of data may occur
if
you do not
follow a procedure as specified.
Take reasonable precautions to prevent electrostatic
discharges to the controller when installing, servicing or
operating the controller. Discharge accumulated static
electricity by touching one’s hand to a well-grounded object
before working with the controller.
Product Parts
a)
Actuator
b)
Position indicator
c)
Mounting bracket
d)
Mounting screws
e)
4 mm hex key
f)
Shaft insert for use with 3/8-inch (8-10 mm) shafts
