Distar DDR, Operation Manual

Page: 15 / 38

Diamond drill bits of DDR, DDS types, L=50-80 mm (DIAMOND ANNULAR DRILL BITS
(САМК), DIAMOND SEGMENTED DRILL BITS (САМС), L=50-80 mm) are not included in the
list of products subject to mandatory certification in the territory of Ukraine.
Drill bits of DDR, DDS TYPES, L=50-80 mm (DIAMOND ANNULAR DRILL BITS (САМК),
DIAMOND SEGMENTED DRILL BITS (САМС), L=50-80 mm) are produced in the accordance
with technical specifications U 28.6-21078963-006:2005. The size and design are indicated
on the product body and packaging.
WARNING:
Please read carefully these Instructions before you start working.
Strictly follow the safety instructions for using the diamond drill bit and the tools you
use;
Before starting any work (moving, replacing tools, etc.) with electric drive machines,
remove the plug from the mains socket or, accordingly, remove the battery from the tools.
Before each use, make a visual check for possible damage to the diamond tool.
Never use a damaged diamond tool.
Damaged, improperly installed or incorrect used diamond instruments can be ex-
tremely dangerous when used!
You should perform your work in protective goggles with side protection (fully protect-
ed mask), respirator, headphones and gloves. You should always use protective footwear
(use an apron, if required).
The material to be processed must be properly secured.
It is prohibited to work without safeguard equipment (see the original operation man-
ual of the equipment manufacturer)!
It is prohibited to work with the lateral surface of the diamond layer (use for grinding
operations);
Attention! IT IS PROHIBITED to use drill bits of DDR, DDS TYPES, L=50-80 mm
(САМК, САМС L=50-80 mm) in striking drilling mode!
RECOMMENDATIONS FOR USE:
Make sure that the diamond tool, which you purchased, is intended for processing the
selected material. Pay attention to guidelines for material, contained in this manual (see.
Table 1, 2, "Abrasiveness of materials").
The outer diameter and landing mounting of a diamond tool shall be made to comply
with equipment characteristics.
APPROPRIATE ASSEMBLY:
Before installing the drill, you should check its landing mounting for the absence of
handling marks, dents or other damages, and if necessary, clear the drill from dirt and dust.
The diamond instrument must be perfectly installed.