2. Screw (1) Caster and (1) Caster with Brake into
the Bo�om Extrusion on Le� Upright. Tighten the
hex nut with wrench.
Do the same to assemble the other (2) casters
with the Right Upright.
3. Align threaded holes in T Plates with holes in
the Media Shelf as shown below. Screw in (2) Flat
Head Screws (K) from each side with a phillips
screw driver.
Assemble the other shelf with (2) T Plates the
same way.
4. Place (1) assembled shelf in the middle of Le� and Right Uprights
and align corresponding holes on them. Fit (1) Rectangular Tube
between (2) T Plates, then screw (2) Hex Screws (I) From each side.
Assemble the other Shelf and Rectangular Tube the same way. Be
sure all Hex Screws are �ghtened.
5. Mount the Hanging Panel onto the assembled Uprights by using
the hardware provided. See image below.
Insert (2) End Cap 2 (C) into the top of uprights.
6. Mount (2) moun�ng brackets to the back of the TV
by using the hardware provided (see below). Choose
the best fit hole in the washer (F).
If the display has a curved back, place the spacer (D)
between the moun�ng bracket and the TV.
7. Adjust the height of the Hanging Panel as needed. Hang
the TV with brackets a�ached onto the Hanging Panel, and
insert the Safety Bar at the bo�om of the Hanging Panel as
shown below.
If you are uncertain about the installa�on or have
any ques�ons on the TV stand, please contact
D2G customer service at 1-800-572-2194.
Insert all End Cap 1 (B) to cover
the screw holes in the Upright.
2 of 2
Ver. 02/18
TV STAND WITH SHELF AND WHEELS - TVJT321G1
