Distance between 2 TVs
Extrution
Tub
e
1. Before starting, measure and calculate the minimum
distance between 2 TVs while hanging on
FLTBSPTBBK
,
without interfering with each other.
2. Avoid fastening
Extrutions
at the joint area of
2
Tubes
, where screws could interfere with the
Extru-
sions
.
3. Hang the lower TV first, then the upper one. It
could be difficult to hang the lower TV last as there
might not be enough room.
* TIPS:
Adjust
Extrution
up and down as
needed for desired result.
NOTE:
(1)
FLTBSPTBBK
can hold dual flat TVs up to 70”, depending
on different layouts and orientation.
(2)
TVs can not be rotated while 2 TVs are hung on the stand at
the same time.
(3) Image on the right shows 2 same size TVs, which the height
is the minimum distance required. STEP 1. must be done if
hanging 2 different size TVs, or hanging any 2 TVs at different
orientations.
FLAT BASE TV STAND
For 2 TVs hanging ONLY
55 Broadcommon Road Bristol, RI 02809, USA Phone: 1-800-572-2194 1-401-247-0333 (Int'l) Fax: 1-401-247-0392
CAUTION: 1. AT LEAST 2 PEOPLE SHOULD LIFT/HANG TVs.
2. BE CAREFUL IF USE LADDERS OR STANDING ABOVE THE GROUND.
3. DO NOT ADJUST THE POSITION OF EXTRUSION WHEN TV IS ON THE BRACKET.
4. DO NOT USE CASTERS. HOLES IN THE BASE ARE FOR MOUNTING ONTO FLOOR ONLY.
2nd operation
Hang Upper TV
1st operation
Hang Lower TV
* TIPS:
It is easier to accomplish this task
by increasing the gas between 2
TVs.
Bracket
mounted on TV can be
adjusted up and down to best fit
and locate both TVs on the stand.
3
Still have questions? No worries. If you’re confused during any step, just call the number located at the
bottom of the Instruction pages. Our friendly representative will be more than happy to assist you.