Endcap
Channel Bar
Adjustable Foot
Fram
e Side
Fra
me
Bo
tto
m
5. Snap four endcap channel bars onto
the sides of the frame.
6. Carefully stand the frame up with the
adjustable feet on the floor.
Note: This may require two people.
7. If the frame is on an uneven
floor or if it leans, adjust the
bottom feet.
8. Snap a light bar onto the center of the “X”
located at the top of the frame.
9. Connect the coiled end of the wire to the
light bar.
10. Snap another light bar onto the center of the “X”
located at the bottom of the frame.
11A. Connect the male end of wire split to the light
bar.
11B. Connect the power supply to the female end of
the wire split. Plug in the power supply to test.
12. Repeat steps 8-11 to install a light bar onto each
“X” on the top and bottom of the frame.
13A. Install the back fabric reflector. Begin by tucking the corners and midway across the
top and bottom. The stitched edge of the silicone goes into the SEG channel first.
13B. Complete installation of the fabric.
Adjustable
Foot
Back of the Frame
Fabric
Reflector
Back
SEG
Channel
Stitched edge
goes in first
SEG
groove
Start in
the corner
Top Frame “X”
Light Bar
Light Bar
Coiled Wire
Bottom Frame “X”
Power Supply
Wire Split
Wire To Top Light
displayit.com 800.207.0311 After-Hours Emergency: Call or Text 678.723.5343
10’ x 10’ Inline Display Kit A
Assembly Instructions
GRAFFITI:Plus
Graffiti:Plus V.2 Updated 10/10/2019
2
