User manual in Original
Doc. ref: 500V_BAS_am_en_210524
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
16 / 35
6. Installation Description for the Machine
6.1. Assembly of the Machine
6.1.1. Mounting the disposer in an Existing Assembly
To minimize the risk of damage, at least two people must be present when the grinder is fixed to
its assembly.
Measure the available clear height (X mm) between the mounting and the floor / floorboard.
Adjust the four legs that are mounted on the disposer’s mounting plate so that the disposer has
the correct height. Correct height is obtained by removing 2 mm from height X.
When the disposer is in place, screw it on with the 3 mm rubber gasket between the disposer
and the assembly. Tighten the screws (6 screws with nut) alternately and evenly until the rubber
gasket is compressed a few millimetres.
6.1.2. Fixation of the Machine
If the disposer can turn in the assembly, or if it is placed freely, for example next to a peeling
machine, the machine must be fixed with a torque protection bar against the wall / bulkhead
according to the figure below. When starting or stopping quickly when stuck (for example if
cutlery accidentally ends up in the disposer), the engine torque can otherwise turn the disposer
so that the outlet pipe / water trap is upset out of position and there is a risk of leakage. If the
torque protection bar is not suitable due to too great a distance to the shot, the feet can be
welded directly to the floor. If torque protection bar cannot be arranged at the installation site, it
is available as an option at Disperator.
6.1.3. Protective lid Connected to Interlock Switch
To comply with the CE mark, the disposer inlet must have an interlock switch connected to a
protective lid mounted above the feed inlet, or similar safety device.
All manuals and user guides at all-guides.com
