Disney DOC McStuffins, Owner'S Manual

Page: 17 / 26

DETAILED MAINTENANCE AND REPAIR
Turn power “OFF” before conducting any maintenance procedures.
Tools Required: Flat head Screwdriver
(not included)
17mm Socket Wrench
(included)
HOW TO REPLACE FRONT WHEELS & REAR LEFT WHEEL
1.
2.
3.
4.
5.
16
Remove the Axle Cap with a flat head screwdriver.
Remove the M10 locknut with a 17mm socket wrench.
Remove the Ø10 washer.
Remove the wheel cover and wheel, then replace with a new one.
Remount the Ø10 washer, M10 locknut and securely tighten the wheel; then
re-insert the axle cap.
IMPORTANT! CHECK GAP AFTER ASSEMBLING WHEELS
After assembling any wheel onto the axles, make sure to check the gap
between the screw thread and the outside of the wheel (refer to the
adjacent diagram). If the gap is too big, add two or three washers on the
axle to the inside of the wheel. After on the axle to the inside of the wheel.
After tightening the nut outside the wheel, please turn the wheel with your
finger to check if the wheel can run smoothly. This is a very important
step because if the wheel can run smoothly, it is ok; but if the nut presses
the wheel and the wheel can’t run smoothly, the motor will be broken
easily! If the wheel does not run smoothly, you will need to decrease
one or two washers to make sure the wheel can run smoothly!
Note:
If the wheel nuts are loose, the wheels will not engage
the forward gear. Tighten the nut with the wrench.
-
GAP