Nano Atomizer Ownership Manual
Remove the disinfectant container (clear bottle) by twisting (see lock/
unlock pic on bottle), turn upside down to reveal the seal. Open the seal
by pulling lightly on the tab, add the disinfectant until you reach desired
level. The markings on the side of the bottle indicate minimum and
maximum levels. Close the seal when finishing filling the container bottle.
Reinsert the container into the handheld, observing the lock/unlock
marking. The bottle should be securely in place before operation.
Powering on:
Plug the Nano Atomizer Handheld in a standard 120-volt circuit. Press the
Gear Position button to the first setting, labelled A. This will power up the
unit, the blue LED will flash while the internal heater comes to
temperature.
Once the LED stops flashing and remains solidly lit, you are ready for
use. Depress the trigger to start spraying atomized disinfectant.
NOTE:
Hold down the Gear Position button for 3 seconds for powering
o
!
the unit. The fan will remain on to ensure airflow within the handheld,
this is normal. After startup, the atomizer will automatically shut down if
it’s standby time exceeds 90 seconds. If the hand switch is not released
after continuous use for more than 10 minutes, the automatic high-
temperature protection device will cause the machine to shut down for
safety purposes.
Directions for Powering On
Vehicle Interiors
– Gear Position C or D
Electronics
– Gear Positions B or C
Fabrics (sofas, drapes, etc)
- Gear Positions A – D
Recommendations
Page 3
