6
2.
Connect the coaxial cables from a DISH 500 or a DISH 300 to the
ports on the DP21 switch labeled
To Dish
as shown in the wiring
diagrams that begin on page 10.
3.
Connect the cable from the satellite receiver port labelled
Satellite
In
to the DP21 port labeled
To Receiver Satellite In
.
Run Check Switch
After you have connected cables and DP21 Switches to all receivers in
the system, run
Check Switch
on each receiver in your system, one at a
time. To do this, follow these instructions which apply to most receivers
or consult your user guide:
1.
Select the
Main Menu, then System Setup,
Installation
, and
Point Dish/Signal
.
2.
A
Point Dish/Signal
menu similar to the one shown as Figure 1
on page 7 will open.
3.
Select
Check Switch.
The
Check Switch
screen will open.
Select
Check
.
Instructions_Small.fm Page 6 Tuesday, January 14, 2003 2:08 PM
