6
discoverbattery.com
M8” bolt (supplied with battery)
Copper compression lug
Shrink-wrap to
color-code the cable
Terminal surface
Lock washer (supplied with battery)
Flat washer (supplied with battery)
Battery cable lug
Ensure nothing is between
the terminal surface and the
battery cable lug
M8” bolt (supplied with battery)
Copper compression lug
Shrink-wrap to
color-code the cable
Terminal surface
Lock washer (supplied with battery)
Flat washer (supplied with battery)
Battery cable lug
Ensure nothing is between
the terminal surface and the
battery cable lug
4.2 VE.Direct MPPT Settings
During normal operation the MPPT charge characteristics are governed by the CCGX via DVCC, with instructions from the
connected AES battery.
The settings below are precautionary. This section presumes familiarity with VictronConnect (Bluetooth App) used to
configure, monitor and diagnose Victron MPPT products which feature Blue-tooth, or are equipped with a VE.Direct Port.
MPPT Charge Controller Settings
44-24-2800
42-48-6650
Battery voltage
24 V
48 V
Max current per battery installed
(Recommended < Maximum)
(9)
installed x
(78 A < 110 A)
installed x
(92 A < 130 A)
Charger enabled
Enabled
Enabled
Battery preset
User Defined
User Defined
Absorption voltage
27.2 V
54.8 V
Maximum absorption time
(10)
1.0 < 3.0 Hr
1.0 < 3.0 Hr
Float voltage
26.8 V
54.0 V
Equalization voltage
26.8 V
54.0 V
Auto equalization
Disabled
Disabled
Temperature compensation
Disabled
Disabled
Low temperature cut off
5
0
C
5
0
C
(9) May be set to lower value if necessitated by charger controller size.
(10)
Duration of absorption period after the bulk charge interval. The recommended minimum is 1.0 hour. A longer
period of time may be required to compensate for multiple batteries to achieve a smooth completion of charge.
5. Installing LYNK and Connecting LYNK to the Victron Network
5.1 Installing the LYNK Edge Card
The LYNK Edge Card for Victron is a Slot 0 Type which only inserts into the left side slot on the bottom of the LYNK
Communication Gateway.
▲
NOTE
•
The LYNK Edge Card type to be used is determine by the brand of power
conversion equipment.
•
If LYNK Edge Card is in the wrong slot, it will not function.
•
If LYNK Edge Card is not firmly seated, it will not function.
Slot 0 Type
