PAGE 32 — ST-70 — PARTS & OPERATION MANUAL — REV. #4 (05/29/07)
10. Retract the jack fully. Remove and store the caster, if
applicable.
11. Check for proper truck-trailer hook-up; the tow vehicle and
trailer should be level with a positive tongue load. For further
information, consult a dealer or Atwood Service Center.
12. The back-up lever knob must be positioned in the “Towing
Position” (Figure 3).
13. Do not use the Atwood brake actuator with a sway
controller, unless prior Atwood Engineering approval of the
sway control system has been received.
14. You are now ready to tow your pump.
CAUTION:
Avoid sharp turns. This could bend, create
extreme stress or fracture either the actuator
or trailer tongue.
BACKING UP
1. Refer to the previous steps 1 through 14 for Towing.
2. Before backing up a slope or through soft ground, pull the
trailer forward slightly to assure that the actuator socket is
in the fully forward position.
3. Move the lever knob on the side of the actuator downward
from the “Towing Position” along the curved slot in the
actuator frame to the “Back-up Position” (Figure 3). The
slot has a notch at the bottom of its travel. Push the lever
knob down to engage the locking notch.
4. Back the trailer up.
CAUTION:
Avoid sharp turns. This could bend, create
extreme stress or fracture either the actuator
or trailer tongue.
ST-70 — TOWING INFORMATION
Fig. 3
Go to Discount-Equipment.com
to order your parts