Elite MicroPrint
Setup Guide
17
Configure Section Options
Configure
: This tab provides a 2
nd
level of ACC
functionality and can be used for upgrading firmware,
calibration and basic testing of the Elite MicroPrint
system. The five options are:
Upgrade System
: This section is used to allow the
upgrade key to be entered and the Elite to add write
drive options
Comm Center
: This section is used to operate all
functions of the auto-loading unit by single command
entries.
Set Positions:
This section allows the posiions that the
Pick Arm stops to be adjusted. This function can be
useful when setting up a new printer.
Program:
This section allows new firmware to be
uploaded in the system.
Diagnostics:
This section is a one click complete self-
diagnostics and provide details about which section
does not check out.
! CAUTION ! ! CAUTION !
This Set Position screen allows you to adjust the position of the Picker Arm when placing CDs in the recorder
and printer. DO NOT change these settings unless instructed to do so by a qualified technician.
! CAUTION ! ! CAUTION !
The ACC allows you to troubleshoot and update your Elite MicroPrint unit. If any electrical or mechanical
issues occur, run the Diagnostics. The ACC Diagnostic routine will test all functions of the autoloader and
provider graphical feedback. The
Comm Port
setting enables you to chose between using COM1 and COM2
when communicating with the Elite MicroPrint. This choice depends upon which of your PC’s serial ports you
plugged the Elite MicroPrint’s serial cable into.
