Operating Instructions
DISAG RM IV
Operating Instructions DISAG RM IV Seite 20
5.9
MENU key
0
MENUE
The standard settings can be altered in the menu which can be called up with this key.
This key can only be used if readiness is indicated in the display. You can move to the
readiness message at any time by pressing the ESC key (possibly several times).
Important!
Alterations made to the standard settings in the machine configuration are also
retained after the
DISAG RM IV
is switched off.
Unprofessional altered standard values can influence the measurement results
provided by evaluation machine.
Repair or service costs incurred as a result of faulty operation are not covered
by the guarantee.
The following is shown on the display:
Start with <*>
Configuration
Now a choice of different menus is given through the ARROW KEYS.
"Configuration", “Typecange”, "Target Values", “PC
-
Protocol”"Language", "Lice
nce" and
"Service menu".
The point indicated in the menu can be called up by means of the ENTER key.
Let us start with the "configuration" menu. Scrolling backwards and forwards is possible
with the ARROW KEYS. As described below we are scrolling forwards (ARROW key from
bottom left to top right).
CONFIGURATION
These call-ups follow one after the other:
Ring tenths (basic setting: no
)
It is possible to set whether evaluation is to follow with or without the ten rings. Operation
is appropriate to the 1/10 key but with the difference that the set values in this case are not
lost when the
DISAG RM IV
is switched off. The ENTER key means "Yes", the CLEAR key
means "No".
DFC tenths (base setting: no
)
The same also applies accordingly for setting the DistanceFromCenter-Value.
