8
Assembly
Handlebar and Contol Assembly
1. Hex bolts and nylon lock nuts have been provided in a
hardware package. Align the two holes at each end of the
handlebar with the two holes in the handlebar support on
the snow blower. Push hex bolts through from the outside
and secure with a nylon lock nut on the interior in two
places on both sides of the snow blower (see Figure 1).
2. Attach the drive wire on the left side of the snow blower
(see Figure 2). Remove the R-clip that connects the drive
wire to the control lever on the handlebars, then slip the
wire off. Attach the other end of the drive wire with the
spring mechanism to the connection ring and reattach the
drive wire to the control lever reinserting the R-clip. After
connecting the wire adjust the tension. The wire should be
taught when connected. (See Control Wire Adjustment,
page 23).
3. Attach the auger wire on the right side of the snow blower
(see Figure 3). Remove the R-clip that connects the auger
wire to the control lever on the handlebars, then slip the
wire off. Attach the other end of the auger wire with the
spring mechanism to the connection and reattach the
auger wire to the control lever reinserting the R-clip. After
connecting the wire adjust the tension. The wire should
be taught when connected. (See Control Wire Adjustment,
page 23).
4. Attach the speed shift rod and secure with a R-clip that has
been included (see Figure 3).
5. Attach the wire harness for heated handle control to the
harness coming off of the engine.
Attaching the Chute Height Control Cable
1. Attach the chute height control cable to the bracket
underneath the control panel. Route the cable through the
notch in the bottom bracket and tighten the two hex nuts
on the top and bottom of the bracket. Then attach the cable
end with the screw eye to the post on the upper bracket
and secure with a R-clip.
NOTE: It will be easiset to attach the screw eye end
of the cable to the bracket post when the chute height
control knob is in the highest position (pulled towards the
operator).
HEX BOLT & NYLON
LOCK NUT
(4 PLACES)
DRIVE
WIRE
Figure 2
Figure 1
AUGER
WIRE
Figure 3
GEAR
CONNECTOR
BAR
CONNECTION
RING
R-CLIP