27
Operation
GB
3
Operation
3.1
Vacuum cleaning
1.
Attach the desired nozzle or pull out the
Z
Chapter 2.2,
"Assembly"
power
Z
Chapter 2.3, "Using further noz-
zles (accessories)"
.
2.
cord by the plug up to the yellow mark (Fig. 9/1).
3.
Insert the mains plug into a socket with ground/safety
contact.
4.
Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 10/1). (The green indicator light is on.)
5.
Set the nozzle switch to "carpet" or "hard floor" accord-
ing to the floor (Fig. 11) to be cleaned:
-
hard floor (Fig. 11/a)
Laminate, tiles, PVC, etc.
-
Carpet (Fig. 11/b)
Short- and deep-pile carpets, rugs, etc.
WARNING:
Danger of injury! A damaged appliance must not be
used. Check the cylinder vacuum cleaner and the power
cord each time before using it.
ATTENTION:
Only use the cylinder vacuum cleaner with all filters
intact, in dry condition and correctly placed. Make sure
that the openings of the vacuum cleaner are not
clogged.or obstructed. Otherwise the vacuum cleaner
might be damaged.
NOTE:
Your cylinder vacuum cleaner is equipped with a safety
switch to prevent overheating. It automatically cuts off
the power supply if the motor is overheated. In this case
switch off the vacuum cleaner with the on/off switch
(Fig. 10/1) and pull the plug from the mains socket. Elim-
inate the cause of overheating (e. g. clogged suction
paths) Wait for about 45 minutes. After it has cooled off,
you may switch on the vacuum cleaner again.
WARNING:
Danger of electric shock! If the red marking shows
(Fig. 9/2) retract the cord by pressing the retract buttonto
pull in the cable (Fig. 10/2) up to the yellow mark again.
Otherwise the cord might break.
9
10
11
02_Twinfinity_gb.book Seite 27 Dienstag, 2. August 2011 7:29 19
Summary of Contents for twinfinity m5040
Page 3: ...3 D 1 ...
