Dirt Devil M612, Instruction Manual

Page: 18 / 152

NOTE:
If you lift the appliance while it is in operation,
the motors switch off automatically after approx-
imately 1 second without floor contact. However,
the appliance is not switched off (the blue LED
is still lit) and starts up again as soon as it makes
contact with a surface.
▶
To switch off the appliance, set ON/OFF switch to
position 0 (Fig.
11
/
B
).
➔
The LEDs go out.
Emptying the dust bin
1
Ensure that the ON/OFF switch is in position
0
(Fig. 11 /
B
).
2
Reach into the recessed grip
(Fig.
7
/
5
) and unlock the cover of the dust bin
(Fig.
7
/
1
).
3
Remove the dust bin comportment
cover (Fig.
7
/
1
) from the appliance (Fig.
14
).
4
Remove (Fig.
15
) the dust bin cover (Fig.
7
/
2
).
5
Carefully pull dust bin with the attached filter from
the appliance (Fig. 16 ).
6
Place dust bin with attached
filter above a waste bin and then separate dust bin
from filter. Tap both parts lightly and remove coarser
debris with a dry cloth.
Cleaning the dust bin and the filter
1
Remove and empty the dust bin > “Emptying
the dust bin” on page 18.
2
Thoroughly rinse dust
bin by hand under running cold water or lukewarm
water.
3
Thoroughly rinse filter by hand under run-
ning cold water or lukewarm water.
4
Allow both
elements to dry at room temperature for at least 24
hours.
5
Reinsert filter into dust bin in such a way
that the plastic grid of the filter is visible. Firmly push
filter into place (Fig. 17 ).
6
Reinsert dust bin with fil-
ter into the appliance > “Inserting dust bin and filter”
on page 18.
Inserting dust bin and filter
1
Reinsert dust bin with attached filter into dust bin
compartment (Fig.
17
).
2
Put dust bin cover firmly
in place until you feel it engage (Fig.
18
).
3
First, put
the dust bin compartment cover in place at the front
so that the 3 tabs on the cover engage in the 3 slots
provided in the dust bin compartment. Now press
against the dust bin compartment cover in the rear
until you hear and feel it click in place (Fig.
19
).
NOTE:
The appliance can only be switched on again if
the cover is positioned correctly.
Removing the battery pack
1
Operate the appliance until the battery pack is
completely empty and the motor of the appliance
stops.
2
Place the ON/OFF switch to position
0
(Fig.
11
/
B
).
3
Firmly remove cover from battery
compartment (Fig.
5
/ OPEN ).
4
Remove the bat-
tery pack.
Accessories
• Round brush (2x) – 0606001 (Fig. 20 /A)
• Filter – 0606002 (Fig. 20 /B)
• Rechargeable battery – 607004 (Fig.
20
/C)
• Mains adapter – 0606003 (Fig.
20
/D)
Troubleshooting
Before you contact our customer service department
or send the appliance to the Dirt Devil customer ser-
vice department, you will find a lot of additional in-
formation in the service area of our website which
will help you solve problems.
www.dirtdevil.de/service
WARNING!
Switch off the appliance before you start trouble-
shooting. Never use a faulty appliance, charger or
rechargeable battery.
!
EN
18