27
3 Operating
G
3
Operating
3.1 Vacuuming
.
1.
Push on the desired nozzle,
Z
Chapter 2.3, "Using other
nozzles (accessories)"
.
2.
Remove the cable, by holding the plug, until the yellow
mark is reached (Fig. 11/1).
3.
Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 11/4).
4.
Adjust the carpet/hard floor switch (Fig. 12) depending
on the type of flooring:
-
Hard floor (Fig. 12/A)
Laminate flooring, tiles, PVC flooring, etc.
-
Carpet (Fig. 12/B)
Long and short pile carpets, runners, etc.
5.
To vacuum, pull the cylinder vacuum cleaner behind
you like a sledge. Observe the recommendations of the
flooring manufacturer.
WARNING:
Check the cylinder vacuum cleaner and the power cable
before each use. A damaged appliance must never be
used. There is a risk of injury.
ATTENTION:
Only use the cylinder vacuum cleaner if all filters are
correctly in place and once you have ensured that no
openings are blocked The filters must be intact and dry.
Non-compliance can damage the cylinder vacuum
cleaner.
WARNING:
If the red mark (Fig. 11/2) is visible, use the cable retract
button (Fig. 11/3) to draw in the cable again up to the
yellow mark (Fig. 11/1). Otherwise the cable can break
off. There is a risk of electric shock.
NOTE:
You can quickly reduce the suction power with the
secondary air controller (Fig. 13/1), e. g. to release
curtains that have been sucked in.
Fig. 11
3
4
2
1
Fig. 12
B
A
Fig. 13
1
02Trimaxx gb.book Seite 27 Mittwoch, 7. März 2007 7:24 19
