Dirt Devil Service line:
AU: 1300 361 505
NZ: 0800 800 900
9
Operation
Start operation
The Robotic Sweeper has 2 modes of operation:
sweeping
mode and
dusting
mode.
1. Be sure the dirt cup filter is installed properly.
2. Place the robotic sweeper in an open area in the room, and turn the Power ON (I=ON).
3. When the robotic sweeper runs out of power, the “BATTERY LOW” LED lamp on the unit will turn RED
and the robotic sweeper will automatically stop.
4. When the robotic sweeper is not in use or prior to recharging, make sure the power switch is in the “OFF”
position (0=OFF).
NOTE:
If you want the robotic sweeper to stay within a particular room be sure to close the door otherwise the
robot may roam from room to room.
NOTE:
The robotic sweeper will stop where it is at when the battery runs out of power.
NOTE:
For locating purposes, the robotic sweeper will beep twice every 60 seconds until the unit is turned off
and is plugged in to charge or until battery is completely depleted.
NOTE:
Lights will flash green/red for a 8 seconds prior till the robot starts cleaning. Lights will continuously flash
green/red when the robotic sweeper is in use. When the batteries are low the red LED will illuminate.
NOTE:
Do not use the robotic sweeper in sweeping mode and dusting mode
at the same time
.
If used in sweeping mode, remove the dusting sheet holder from the underside of the robotic sweeper.
If used in dusting mode, remove the side brushes from the unit.
