7
10
Some of the following symbols may be used on this product. Please study them and learn their
meaning. Proper interpretation of these symbols will allow you to operate the product much better.
SYMBOL
NAME
DESIGNATION/EXPLANATION
Safety Alert
Indicates a potential personal injury hazard.
Read Operator’s Manual
To reduce the risk of injury, user must read and
understand operator’s manual before using this
product.
Eye and Hearing Protection
Always wear eye protection with side shields
marked to comply with ANSI Z87.1 along with
hearing protection.
Wet Conditions Alert
Do not expose to rain or use in damp locations.
Keep Bystanders Away
Keep all bystanders at least 50ft. away.
Long Hair
Failure to keep long hair away from the air inlet
could result in personal injury.
Loose Clothing
Failure to keep loose clothing from being drawn
into air intake could result in personal injury.
V
Volts
Voltage
A
Amperes
Current
Hz
Hertz
Frequency (cycles per sound)
W
Watt
Power
min
Minutes
Time
Alternating Current
Type of current
Direct Current
Type or a characteristic of current
Class II Construction
Double-insulated construction
SYMBOLS
HOW TO ASSEMBLE
UNPACKING:
This product requires assembly.
Carefully remove the product and any accessories from the box. Make sure that all
items listed in the packing list are included.
BLOWER MODE:
Put blower attachment (A1) on blower tube (A2) so
arrows are on same side.
Align the grooves on the blower tube (A) Fig.3 with the
grooves on the blower outlet (B). Push the blower
tube onto the blower outlet until it clicks into posi-
tion.
Warning!
The blower inlet and outlet both have a
built-in limit switch which
prevents the blower from starting if the blower
tube (A) and the blower inlet safety guard (C) are
not installed or not installed properly. Make sure
the blower tube and blower inlet safety guard are
installed before attempting to use the blower.
To install the blower inlet safety guard (A) Fig.4 to
the blower inlet, position the blower inlet safety
guard over the blower inlet, rotate the safety guard
approximately 90 degrees. Make sure the safety
guard has engaged the blower inlet grooves, at
this point you must not be able to lift the safety
guard upwards. Make sure the limit switch actua-
tor (B) engages the inner limit switch, then lock the
blower inlet safety guard using the locking clip (C).
The blower is now ready to use, make sure you
have read and understood the safety and operation
instructions before using.
It is recommended to install the adjustable shoulder
strap (D) Fig.3 to the blower handle (E).
• Inspect the product carefully to make sure no breakage or damage occurred dur-
ing shipping.
• Do not discard the packing material until you have carefully inspected and satis-
factorily operated the product.
• If any parts are damaged or missing, please call 1-800-321-1134 for assistance.
WARNING:
Do not use this product if any parts on the Packing List are already assembled to your
product when you unpack it. Parts on this list are not assembled to the product by the
manufacturer and require customer installation. Use of a product that may have been
improperly assembled could result in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could result in serious personal injury.
Figure 3
Figure 4
Figure 5
2
A 1
