page 33 of 44
D.O.TEC
®
ANDIAMO 2.AD Hardware Guide - Version 1.0
DirectOut Technologies
®
CHAPTER 5: Menu Navigation
© 2013 DirectOut GmbH
•
Press the button <SELECT> longer than two seconds to enter
the menu mode
•
Press <SELECT> to navigate through the menu-loop.
•
Press <SET> to change a setting.
In menu mode the active parameter for adjusting is indicated by a
blinking LED. This LED refl ects the setting of this parameter.
System Settings
Parameter <Clock>
Three different clock sources: word clock, MADI, internal
Internal allows for changing the base sample rate.
Parameter <sample Rate>
Two base sample rates: 44.1 kHz and 48 kHz
Two scaling factors: 1 FS and 2 FS
The setting of the base sample rate only affects the conversion with
the clock source set to INT. If the clock source is set to word clock
or MADI input no adjustment is possible - the measured frequency
of the clock source is indicated then.
Parameter <sync>
(monitoring only)
Indication of selection and lock/sync state of MADI input 1 and 2.
Parameter <bank>
Two banks allow for selection of 32 audio channels out of 64 audio
channels at a scaling factor of 1 FS. At 2 FS only 32 audio channels
are transmitted in a MADI signal. ‘Matrix Mode’ can be activated or
disabled.
Parameter <format>
The channel format (56 ch or 64 ch) as well as the frame format
(48k Frame or 96k Frame) of the MADI output can be adjusted.
This setting does not affect the input signal.
