P a g e
|
2
DSE3-50 Rev 6/20
BEFORE INSTALLING YOUR NEW ANTENNA, PLEASE BE SURE
TO READ THE ENCLOSED WARNING PAMPHLET.
ASSEMBLY TIPS AND NOTES
TOOLS
Assembly of your antenna kit requires the following tools.
12’ or greater tape measure
#2 Phillips screwdrivers
7/16” wrench or rachet and socket
Permanent marker (Sharpie)
Pliers
ASSEMBLY TIPS
1.
Read an entire section before performing each assembly operation.
2.
This Manual contains assembly drawings and other assembly-related information such as
element lengths. Drawings are referred to by
Figure
number; charts and lists are referred to
by
Table
number. Continue using the same Table or Figure number until told to use a different
one.
3.
All of the information needed to successfully complete the construction of an antenna kit is
contained in this Manual. Keep this Manual in a safe place so that it will be available should
you require it for future reference.
4.
When tightening hardware
FOLLOW INSTRUCTIONS
– DO NOT OVER TIGHTEN!
Deformation of the boom may occur, causing misalignment of elements.
5.
Orient all hardware as instructed in each assembly step and as may be shown in an
associated figure.
Elements will be called out by their position on the boom, R = reflector, DE = driven element and D-
element number = director. The director’s number is relative to the DE element with D-1 nearest the
DE. The elements are marked R, DE and D.
