7
© 2018 Directed. All rights reserved.
Pin Number Setting
Factory Preset Pin Number: 1 (Led Blinks One Time)
In disarming mode,
turn
ignition ON/OFF 8 times within 15 sec-
ond, and end in ON position on the eighth time. The LED will stay
solid for 2 seconds, then the system enters into PIN setting mode:
1.
Confirm the original (preset) PIN Number
Turn
the ignition OFF within 10 second, LED will start blink-
ing slowly to confirm the preset PIN Number.
Turn
the igni-
tion ON once the LED blinks the number of times correspond-
ing to the original preset PIN number. If correct, the siren will
chirp once (if siren does not chirp, it means the preset PIN
number confirmation failed. Start the process over again if
this happens);
2.
Input the new PIN NUMBER
Right after the siren chirp once,
turn
the ignition Off, and the
system enters into new PIN number setting, and LED starts
to flash. When the LED flashes the number of times wanted
for the new PIN number,
turn
the ignition ON then OFF. The
LED will flash the new PIN number once, and then exit PIN
NUMBER setting mode.
Exit Pin Number Setting
If no operation is performed or the wrong initial password was
entered within 30 seconds, the system will exit PIN NUMBER set-
ting mode.
Valet Mode
You can prevent your security system from automatically arming by
using valet mode, this is very useful when washing the motorcycle,
for example. In valet mode, the security system will not arm, even
with the transmitter, but any accessory functions will continue to
work normally.
